This fixes subpage writes when using 4-bit HW ECC.
There has been numerous reports about ECC errors with devices using this
driver for a while. Also the 4-bit ECC has been reported as broken with
subpages in [1] and with 16 bits NANDs in the driver and in mach* board
files both in mainline and in the vendor BSPs.
What I saw with 4-bit ECC on a 16bits NAND (on an LCDK) which got me to
try reinitializing the ECC engine:
- R/W on whole pages properly generates/checks RS code
- try writing the 1st subpage only of a blank page, the subpage is well
written and the RS code properly generated, re-reading the same page
the HW detects some ECC error, reading the same page again no ECC
error is detected
Note that the ECC engine is already reinitialized in the 1-bit case.
Tested on my LCDK with UBI+UBIFS using subpages.
This could potentially get rid of the issue workarounded in [1].
[1] 28c015a9daab ("mtd: davinci-nand: disable subpage write for keystone-nand")
Signed-off-by: Karl Beldan <kbel...@baylibre.com>
---
drivers/mtd/nand/davinci_nand.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
index cc07ba0..27fa8b8 100644
--- a/drivers/mtd/nand/davinci_nand.c
+++ b/drivers/mtd/nand/davinci_nand.c
@@ -240,6 +240,9 @@ static void nand_davinci_hwctl_4bit(struct mtd_info *mtd,
int mode)
unsigned long flags;
u32 val;
+ /* Reset ECC hardware */
+ davinci_nand_readl(info, NAND_4BIT_ECC1_OFFSET);
+
spin_lock_irqsave(&davinci_nand_lock, flags);
/* Start 4-bit ECC calculation for read/write */
--
2.9.2
