The list of "Too many errors!" usually appears if you haven't upgraded to a very new version of texinfo. However, it only affects the documentation, so as long as you use the documentation on the web, make followed by make install should provide a perfectly useful installation.
/Mats
Tapio Tuovila wrote:
LinuxChiq wrote:
I am trying to build Lilypond 2.4.2 on Suse 9.1. I have gotten ./configure to
complete without errors, but when I make all it bails with a long list of
Too many errors! Gave up.
I don't see an install.log - where can I find out what the problem is?
Cheers,
Raven
Hi,
you can roll backwards your console screen, the cause of the problem is being printed somewhere near the beginning of the error list. As far as I recall there were some (two? three?) packages missing, even if ./configure completes OK.
But 2.4.2 can be built on Suse 9.1 OK.
best regards,
Tapio
_______________________________________________ lilypond-user mailing list [EMAIL PROTECTED] http://lists.gnu.org/mailman/listinfo/lilypond-user
-- ============================================= Mats Bengtsson Signal Processing Signals, Sensors and Systems Royal Institute of Technology SE-100 44 STOCKHOLM Sweden Phone: (+46) 8 790 8463 Fax: (+46) 8 790 7260 Email: [EMAIL PROTECTED] WWW: http://www.s3.kth.se/~mabe =============================================
_______________________________________________ lilypond-user mailing list [EMAIL PROTECTED] http://lists.gnu.org/mailman/listinfo/lilypond-user
