would be cool to find a 200 for sure. Kind Regards,
Timothy J. Ziegler Ziegler WoodWork & Specialty Ziegler Laser Worx LLC 14171 160th Ave. Foreston MN 56330 320-294-5798 shop 320-630-2243 cell On Tue, Feb 25, 2025 at 10:53 PM 'Curt George' via Legacy Ornamental Mills < legacy-ornamental-mills@googlegroups.com> wrote: > HI everyone. > Was just looking and found this photo. (yes its marked REVO but it is the > Legacy 200) > I have asked the question in the past. > But I think I will again. HOW To make a better mousetrap. this little > machine should not be all that hard to make, > using parts like linear slides. > But the gearing would be a problem. I was just thinking, how about an > electronic gear box or sorts? I dont know much about > CNC, but would it be hard to make a simple program for a small machine > like this? servo motors are cheap, gearing although old > school is much harder to make today. Could it be done at a reasonable > price? > What would be the best way to make this type of small machine???? > > C.A.G. > > -- > You received this message because you are subscribed to the Google Groups > "Legacy Ornamental Mills" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to legacy-ornamental-mills+unsubscr...@googlegroups.com. > To view this discussion visit > https://groups.google.com/d/msgid/legacy-ornamental-mills/27012577.2543490.1740545587740%40mail.yahoo.com > . > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To view this discussion visit https://groups.google.com/d/msgid/legacy-ornamental-mills/CAMBiJLEL%3DwKEUU4yc_wxsvPvEKXe1vSowNNtk4DNAXTD76%2BA_Q%40mail.gmail.com.
