On Thu, Nov 9, 2017 at 5:38 PM, Koen Vandeputte <koen.vandepu...@ncentric.com> wrote: > > > On 2017-11-09 16:40, Outback Dingo wrote: >> >> On Thu, Nov 9, 2017 at 4:16 PM, Koen Vandeputte >> <koen.vandepu...@ncentric.com> wrote: >>> >>> >>> On 2017-11-09 15:55, Outback Dingo wrote: >>>> >>>> heres more data, we still have a no interfaces issue with recent LEDE >>>> trunk >>>> >>>> >>>> >>>> On Thu, Nov 2, 2017 at 6:42 PM, Outback Dingo <outbackdi...@gmail.com> >>>> wrote: >>>>> >>>>> seems that ive lost my eth0 / eth1 interfeaces on a RECENT ... today >>>>> image built for the gw5520 >>>>> i do however see the ifb0 and ifb1 interfaces... any ideas? >>> >>> >>> Hi, >>> >>> As I have similar hardware, maybe I can help out. (GW 5510 and others) >>> >>> I'm not seeing the FEC driver being loaded in your log: (Freescale >>> Ethernet) >>> >>> >>> Snip from my 5510: >>> >>> >>> [ 0.692354] libphy: Fixed MDIO Bus: probed >>> [ 0.693357] libphy: mdio_driver_register: mv88e6085 >>> [ 0.695036] 2188000.ethernet supply phy not found, using dummy >>> regulator >>> [ 0.697541] pps pps0: new PPS source ptp0 >>> [ 0.701333] libphy: fec_enet_mii_bus: probed >>> >>> --> [ 0.702005] fec 2188000.ethernet eth0: registered PHC device 0 >>> >>> >>> >>> Please run "make kernel_menuconfig" and check if CONFIG_FEC is >>> selected. >>> >>> >> >> >> Hi, the following were selected under drivers / ethernet >> >> [*] Freescale devices >> │ │ >> │ │ <*> FEC ethernet controller >> (of ColdFire and some i.MX CPUs) >> │ │ >> │ │ < > Freescale PQ MDIO >> │ │ >> │ │ < > Freescale XGMAC MDIO >> │ │ >> │ │ < > Gianfar Ethernet >> │ │ >> │ │ [*] Hisilicon devices >> >>> Kind Regards, >>> >>> Koen > > > Hi, > > Quickly checked a little more in-depth. > > (My board is a GW52xx.) > > Looking at dtsi, it seems that the fec part is not specified for the 552x > > As a test, could you add attached patch to your build? > Just put it in target/linux/imx6/patches-4.9 and do a full rebuild (make > clean; make)
This board was working fine with LEDE in September? so im curious how a dtsi file would regress in a few weeks > > > Thanks, > > Koen _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev
