I've experienced this problem with a number of KX-TD816-4 and KX-TD1232-4 (I haven't experimented with -5 yet) systems. I found that, immediately after performing batch programming using the E1232A.EXE software, the message waiting keys that were programmed on flexible buttons wouldn't always work correctly. More specifically, if a new message was left in the mailbox, the light would not be lit, but the button would function to retrieve the message, as if it were lit. After some experimentation, I found that if I power the system down (or use the reset button) after performing batch programming, that the lights seem to work fine afterwards. It is a little bit of a pain to have to shut the system down after batch programming, though.
I know that some of the -4 feature enhancements require that you reset the system after programming, but I don't recall that flexible message waiting lights was one of the features that required this. Bob -----Original Message----- Hi.... Great little forum here... Hopefully someone can help me with a little problem I have. I setup a phone so that 3 dss buttons were setup as Message waiting lights for 3 mailbox's. But the lights wont turn on and off. If I unplug the phone and plug it back in, the lights will show correctly but they dont turn on or off without having to unplug the phone. I have tried reseting the system and reprograming with the same results. I am running a kx-td1232-4 system. Any help would be appreciated. Thanks! _________________________________________________________________ KX-T Mailing list --- http://kxthelp.com/ Subscription changes: http://kxthelp.com/mailman/listinfo/kxt
