Thats an AN bolt? I wouldn't think they would shear like that since they are more elastic than a Home Airport Depot Grade 8......
________________________________ From: KRnet <krnet-boun...@list.krnet.org> on behalf of robert7721--- via KRnet <krnet@list.krnet.org> Sent: Monday, February 24, 2025 5:32 PM To: 'KRnet' <krnet@list.krnet.org> Cc: robert7...@aol.com <robert7...@aol.com> Subject: Re: KRnet> Need a Propellor and nose fork assembly. Don’t see this one as a regular maintenance item, looks like a fatigue failure. I do have over 1100 hours on it, lots of landings to go with that as well. This is buried in the nose wheel assembly pretty deep. You don’t even disassemble this when installing it during building. Not sure how to check. Definitely would have thought the strut would fail before this bolt. Maybe during the annual inspection, you could get the nose gear off the ground and rotate it and check for issues. Rob From: KRnet <krnet-boun...@list.krnet.org> On Behalf Of Larry Flesner via KRnet Sent: Monday, February 24, 2025 4:02 PM To: robert7721--- via KRnet <krnet@list.krnet.org> Cc: Larry Flesner <fles...@frontier.com> Subject: Re: KRnet> Need a Propellor and nose fork assembly. On 2/24/2025 1:21 PM, robert7721--- via KRnet wrote: Looks like the original nose gear failed at the lower assembly. The through-bolt sheared. I am going to take it apart, but not sure I can fix it. ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ Is this an item that everyone with similar setup should check before next flight? Was the bolt worn? I tried to make it a habit on annual inspection to rotate any bolt that was capable of rotation such as in control cable connections. I would give each a 1/4 turn to cut the wear rate by a factor of 4. Larry Flesner
-- KRnet mailing list KRnet@list.krnet.org https://list.krnet.org/mailman/listinfo/krnet
