"what is the proper method to cut the control to size? "
Hello Alex, I have a normal throttle cable, a vernier, and a ratcheting type cable control that works great for vents. In all cases I just installed the cable where I wanted it and marked the end where it needed to be cut. I then removed the knob with the internal cable attached and cut the sheath with a Dremel tool with an abrasive disk. I then ran a fine file around the cut edge just to give it a little chamfer and reinstalled the knob and wire. Then cut the cable to the length that you need. If I remember correctly it may have been the vernier that had some internal components so when you take it apart be careful with it. Stephen Teate Paradise, Texas The information in this email is confidential and may be legally privileged. If you are not an intended recipient, you should delete this message. Access to this email by anyone else is unauthorized, and any disclosure, copying, distribution or action taken or omitted in reliance on it is prohibited and may be unlawful.
