The crosshair behavior is canvas dependent. In the legacy canvas, the crosshairs (full screen or small) are always shown. In the modern canvases, the crosshairs are only show when a tool is active and the option is disabled. Enabling the option makes the modern canvas behavior the same as the legacy canvas.
On 2/7/2018 3:37 PM, Jeff Young wrote: > Oh wait, bells are ringing. > > The disclaimer on the checkbox is OSX-only. Other platforms support it even > in legacy, don’t they? > > > >> On 7 Feb 2018, at 20:28, Wayne Stambaugh <stambau...@gmail.com> wrote: >> >> I just looked and there is no mention of legacy or modern in the >> checkbox string. There is a "not supported in legacy graphics" note in >> the grid options but not the crosshair setting. >> >> On 2/7/2018 2:24 PM, Jeff Young wrote: >>> We already did. Well: “Always display crosshairs (not in Legacy)”, anyway. >>> >>> >>>> On 7 Feb 2018, at 19:21, Wayne Stambaugh <stambau...@gmail.com> wrote: >>>> >>>> On 2/7/2018 1:54 PM, jp charras wrote: >>>>> Le 07/02/2018 à 19:44, Wayne Stambaugh a écrit : >>>>>> If you are using a gal canvas, the only time you see the cross hairs is >>>>>> when a tool is selected. This is true of even the small cross hairs. >>>>> >>>>> Yes, but if in Preferences/Display Options you enable "Always display >>>>> crosshairs" you should have >>>>> the crosshair cursor always displayed. >>>> >>>> So that's what that option is for! We really should change the text to >>>> is "Always display crosshairs in modern canvas" since this has no effect >>>> on the legacy canvas. >>>> >>>>> >>>>>> >>>>>> On 2/7/2018 1:41 PM, Bernhard Stegmaier wrote: >>>>>>> Yes, did see the button (synced today). >>>>>>> But it didn’t seem to change anything. >>>>>>> Where should I see it? >>>>>>> >>>>>>>> On 7. Feb 2018, at 19:39, Jeff Young <j...@rokeby.ie> wrote: >>>>>>>> >>>>>>>> The crosshairs should be available again in a current build. Do you >>>>>>>> see the toolbar button on the left? >>>>>>>> >>>>>>>>> On 7 Feb 2018, at 17:36, Bernhard Stegmaier <stegma...@sw-systems.de> >>>>>>>>> wrote: >>>>>>>>> >>>>>>>>> … yes, no good. >>>>>>>>> It seems to be OK when just panning around. >>>>>>>>> But, it gets very laggy while e.g. dragging/moving symbols around >>>>>>>>> (even on a not so big schematic I had at hand). >>>>>>>>> >>>>>>>>> It is fine if you take out the Refresh() quoted below on macOS. >>>>>>>>> I didn’t see any obvious things on a quick check with the remaining >>>>>>>>> changes (might be due to the fact that crosshair is still disabled on >>>>>>>>> macOS?). >>>>>>>>> >>>>>>>>> >>>>>>>>> Regards, >>>>>>>>> Bernhard >>>>>>>>> >>>>> >>>>> >>>> >>>> _______________________________________________ >>>> Mailing list: https://launchpad.net/~kicad-developers >>>> Post to : kicad-developers@lists.launchpad.net >>>> Unsubscribe : https://launchpad.net/~kicad-developers >>>> More help : https://help.launchpad.net/ListHelp >>> > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
