Oh wait, bells are ringing. The disclaimer on the checkbox is OSX-only. Other platforms support it even in legacy, don’t they?
> On 7 Feb 2018, at 20:28, Wayne Stambaugh <stambau...@gmail.com> wrote: > > I just looked and there is no mention of legacy or modern in the > checkbox string. There is a "not supported in legacy graphics" note in > the grid options but not the crosshair setting. > > On 2/7/2018 2:24 PM, Jeff Young wrote: >> We already did. Well: “Always display crosshairs (not in Legacy)”, anyway. >> >> >>> On 7 Feb 2018, at 19:21, Wayne Stambaugh <stambau...@gmail.com> wrote: >>> >>> On 2/7/2018 1:54 PM, jp charras wrote: >>>> Le 07/02/2018 à 19:44, Wayne Stambaugh a écrit : >>>>> If you are using a gal canvas, the only time you see the cross hairs is >>>>> when a tool is selected. This is true of even the small cross hairs. >>>> >>>> Yes, but if in Preferences/Display Options you enable "Always display >>>> crosshairs" you should have >>>> the crosshair cursor always displayed. >>> >>> So that's what that option is for! We really should change the text to >>> is "Always display crosshairs in modern canvas" since this has no effect >>> on the legacy canvas. >>> >>>> >>>>> >>>>> On 2/7/2018 1:41 PM, Bernhard Stegmaier wrote: >>>>>> Yes, did see the button (synced today). >>>>>> But it didn’t seem to change anything. >>>>>> Where should I see it? >>>>>> >>>>>>> On 7. Feb 2018, at 19:39, Jeff Young <j...@rokeby.ie> wrote: >>>>>>> >>>>>>> The crosshairs should be available again in a current build. Do you >>>>>>> see the toolbar button on the left? >>>>>>> >>>>>>>> On 7 Feb 2018, at 17:36, Bernhard Stegmaier <stegma...@sw-systems.de> >>>>>>>> wrote: >>>>>>>> >>>>>>>> … yes, no good. >>>>>>>> It seems to be OK when just panning around. >>>>>>>> But, it gets very laggy while e.g. dragging/moving symbols around >>>>>>>> (even on a not so big schematic I had at hand). >>>>>>>> >>>>>>>> It is fine if you take out the Refresh() quoted below on macOS. >>>>>>>> I didn’t see any obvious things on a quick check with the remaining >>>>>>>> changes (might be due to the fact that crosshair is still disabled on >>>>>>>> macOS?). >>>>>>>> >>>>>>>> >>>>>>>> Regards, >>>>>>>> Bernhard >>>>>>>> >>>> >>>> >>> >>> _______________________________________________ >>> Mailing list: https://launchpad.net/~kicad-developers >>> Post to : kicad-developers@lists.launchpad.net >>> Unsubscribe : https://launchpad.net/~kicad-developers >>> More help : https://help.launchpad.net/ListHelp >> _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : kicad-developers@lists.launchpad.net Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp