On 4/6/2011 1:37 PM, Dick Hollenbeck wrote: > On 04/06/2011 12:33 PM, Wayne Stambaugh wrote: >> On 4/6/2011 1:15 PM, jean-pierre charras wrote: >>> Le 06/04/2011 18:43, Dick Hollenbeck a écrit : >>>> On 04/06/2011 11:41 AM, Dick Hollenbeck wrote: >>>>> On 04/06/2011 11:38 AM, Dick Hollenbeck wrote: >>>>>> So did we go back and fix the zoom steps? I remember one step was >>>>>> commented >>>>>> out: 0.7. >>>>>> >>>>>> It needs to be enabled now, and absolutely so on Linux. >>>>> Currently on Linux, if you start eeschema without loading a schematic, the >>>>> sheet border is off screen on top and bottom, suggesting the initial zoom >>>>> is >>>>> not optimal for viewing the border. >>>>> >>>>> Is this intentional? >>>> It happens in any loading of a schematic, and any sheet change within a >>>> schematic also, and therefore cannot be intentional. >>>> >>> I do not have this problem. >>> Is it a recent issue (BestZoom() was slightly modified in eeschema to fix >>> issue >>> for zoom = 0.7) ? >>> >> I have the same problem as well when the aspect ratio of the drawing window >> is >> not close to that of the schematic page size. If wxWidgets 2.9 takes care of >> the non-integer zoom sizes and the problem doesn't exist on Linux or OSX, why >> not revert to the old behavior of best zoom and put 0.7 back into the zoom >> list >> if we are going to make wxWidget 2.9 a build requirement on windows? > > Exactly. > > Do you know this NOT to be the case at this moment?
If you are referring to the best zoom behavior I was under the impression that JP was still sorting that out. That may have been a poor assumption on my part. If you are talking about wxWidgets 2.9 being the required version for building kicad on windows, I wasn't aware that a decision has been made. I thought it was just a proposal by JP. In any event, we should create a cmake macro to verify the version of wxWidgets found is correct. Wayne > > > > _______________________________________________ > Mailing list: https://launchpad.net/~kicad-developers > Post to : [email protected] > Unsubscribe : https://launchpad.net/~kicad-developers > More help : https://help.launchpad.net/ListHelp > _______________________________________________ Mailing list: https://launchpad.net/~kicad-developers Post to : [email protected] Unsubscribe : https://launchpad.net/~kicad-developers More help : https://help.launchpad.net/ListHelp
