Ok I just found in the logs : Incompatible SFP transceiver for interface TenGigabitEthernet 0/35 is detected
Which is weird those are supposed to be compatible with ? 1GE-XBR-000190 Maybe a firmware update could fix this ? (hard to say without support) Or this is expected to not be compatible ? Thanks ---- On Tue, 04 Sep 2018 13:44:29 +0200 Mathieu Poussin <m...@mpouss.in> wrote ---- > Hello. > > Je suis en train de configurer un Brocade VDX (gray market donc pas de > support malheureusement). > > Impossible de monter un LACP, en faite c'est assez bizarre, le Port-Channel > monte bien mais impossible de no shut les membres (Qui sont des ports 10g > mais avec des sfp copper 1g), exemple : > > bcn-sws-3-1# show port-channel 1 > LACP Aggregator: Po 1 > Aggregator type: Standard > Admin Key: 0001 - Oper Key 0001 > Partner System ID - 0x0000,00-00-00-00-00-00 > Partner Oper Key 0000 > Member ports: > Link: Te 0/35 (0x18118184) sync: 0 > Link: Te 0/40 (0x18140189) sync: 0 > Link: Te 0/55 (0x181B8284) sync: 0 > Link: Te 0/60 (0x181E0289) sync: 0 > > bcn-sws-3-1# sh run int po 1 > interface Port-channel 1 > speed 1000 > description Uplink to BCN-SWC-3-1 > switchport > switchport mode trunk > switchport trunk allowed vlan add 110-112 > switchport trunk tag native-vlan > no shutdown > ! > > bcn-sws-3-1(config)# int te 0/35 > bcn-sws-3-1(conf-if-te-0/35)# no shut > bcn-sws-3-1(conf-if-te-0/35)# end > bcn-sws-3-1# sh run int te 0/35 > interface TenGigabitEthernet 0/35 > speed 1000 > description Uplink > channel-group 1 mode active type standard > lacp timeout long > shutdown # << wtf? > ! > > > bcn-sws-3-1# sh int te 0/35 > TenGigabitEthernet 0/35 is admin down, line protocol is down (admin down) > Hardware is Ethernet, address is 0005.334b.f97e > Current address is 0005.334b.f97e > Pluggable media not present > Description: Uplink > Interface index (ifindex) is 403800452 > MTU 2500 bytes > LineSpeed Actual : Nil > LineSpeed Configured : 1000 Mbit, Duplex: Full > Priority Tag disable > IPv6 RA Guard disable > Last clearing of show interface counters: 03:39:48 > Queueing strategy: fifo > Receive Statistics: > 0 packets, 0 bytes > Unicasts: 0, Multicasts: 0, Broadcasts: 0 > 64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0 > Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0 > Over 1518-byte pkts(Jumbo): 0 > Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0 > Errors: 0, Discards: 0 > Transmit Statistics: > 1960 packets, 289098 bytes > Unicasts: 8, Multicasts: 1302, Broadcasts: 650 > Underruns: 0 > Errors: 0, Discards: 0 > Rate info (interval 299 seconds): > Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate > Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate > Time since last interface status change: 00:44:44 > > > Le "Pluggable media not present" me porte a confusions vu que j'ai d'autre > ports 10g qui sont up, fonctionnent bien mais qui retournent aussi ça, > exemple: > > bcn-sws-3-1# sh int te 0/1 > TenGigabitEthernet 0/1 is up, line protocol is up (connected) > Hardware is Ethernet, address is 0005.334b.f95c > Current address is 0005.334b.f95c > Pluggable media not present > Description: STORAGE > Interface index (ifindex) is 402685952 > MTU 2500 bytes > LineSpeed Actual : 10000 Mbit > LineSpeed Configured : Auto, Duplex: Full > Priority Tag disable > IPv6 RA Guard disable > Last clearing of show interface counters: 03:42:41 > Queueing strategy: fifo > Receive Statistics: > 145608 packets, 29709612 bytes > Unicasts: 144478, Multicasts: 940, Broadcasts: 190 > 64-byte pkts: 112543, Over 64-byte pkts: 15686, Over 127-byte pkts: 2810 > Over 255-byte pkts: 730, Over 511-byte pkts: 613, Over 1023-byte pkts: > 13226 > Over 1518-byte pkts(Jumbo): 0 > Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0 > Errors: 0, Discards: 0 > Transmit Statistics: > 1176133 packets, 1658862747 bytes > Unicasts: 1174922, Multicasts: 952, Broadcasts: 259 > Underruns: 0 > Errors: 0, Discards: 0 > Rate info (interval 299 seconds): > Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate > Output 0.000708 Mbits/sec, 0 packets/sec, 0.00% of line-rate > Time since last interface status change: 01:19:15 > > La version (Pas de support donc pas de MAJ malheureusement...): > > bcn-sws-3-1# show ver > > Network Operating System Software > Network Operating System Version: 4.1.1 > Copyright (c) 1995-2014 Brocade Communications Systems, Inc. > Firmware name: 4.1.1 > Build Time: 19:48:22 Mar 19, 2014 > Install Time: 12:34:44 Mar 23, 2015 > Kernel: 2.6.34.6 > > BootProm: 2.2.0 > Control Processor: e500v2 with 2048 MB of memory > > Appl Primary/Secondary Versions > ------------------------------------------ > NOS 4.1.1 > 4.1.1 > > Une idée? > Pas d'accès aux forums Brocade non plus sans support alors que la réponse y > est surement... > > Merci > > > > --------------------------- > Liste de diffusion du FRnOG > http://www.frnog.org/ > --------------------------- Liste de diffusion du FRnOG http://www.frnog.org/
