External Email - Use Caution
Hi Jason
There are morphological tools built into freeview, so you could select a single
vertex, make a label from it, then dilate it as many times as you want. That
will of course give you the graph distance not the actual surface geodesic, but
might be good enough?
Cheers
Bruce
From: freesurfer-boun...@nmr.mgh.harvard.edu
<freesurfer-boun...@nmr.mgh.harvard.edu> On Behalf Of Jason Tourville
Sent: Wednesday, August 23, 2023 12:27 PM
To: Freesurfer support list <freesurfer@nmr.mgh.harvard.edu>
Subject: [Freesurfer] surface label generation from vertex?
External Email - Use Caution
Hi Freesurfers,
I would like to generate a label that extends some distance from a chosen
vertex on the surface. Is this possible in the freeview gui? Otherwise?
Many thanks for you feedback.
Best,
Jason
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
