Hello Freesurfer Developers,
I am having trouble with my first level analysis using selxavg3-sess. I passed the -debug flag in my command and noticed that MATLAB 2021a was being used. However, the command worked as expected before MATLAB was updated from 2020b. Is there a way I can specify freesurfer (v6.0.0) to use a specific version of MATLAB? I tried passing the -octave flag but got the following error ERROR: cannot find /usr/local/freesurfer/stable5_1_0/matlab/ The full command: selxavg3-sess -s 002_S_0413_V1_fMRI -overwrite -a lh-FastADNI12state1 -no-preproc -force -debug Thank you Shrikanth
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at http://www.massgeneralbrigham.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail. Please note that this e-mail is not secure (encrypted). If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately. Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.
