What platform are you using?
On 10/20/2021 11:02 AM, DIANA ORTEGA CRUZ wrote:
External Email - Use Caution
Dear FreeSurfer team,
I am experiencing a display problem in the FreeView version of
FreeSurfer 7 for inflated surfaces. The inflated surfaces from my
fsaverage folder look as in the screenshot attached, missing the gyri
and sulci coloring and having a see-through pattern. My FreeView
version is 3.0 Build Jul 23 2020. One of my colleagues tested opening
inflated surfaces using different versions of FreeView, and these also
look see-through using a version from FS7, but not using a version
from FS6. Have any of you encountered a similar display for inflated
surfaces? Do you know if this could be changed?
Any advice would be much appreciated!! Thanks a lot.
Best,
Diana Ortega Cruz.
PhD Student**
Laboratory for Clinical Neuroscience
Centro de Tecnología Biomédica - Universidad Politécnica de Madrid
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at http://www.massgeneralbrigham.org/complianceline . If
the e-mail was sent to you in error but does not contain patient information,
please contact the sender and properly dispose of the e-mail.
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
