External Email - Use Caution If I load, say, orig.mgz and lh.pial, in FreeView and lay my cursor on a point, I can see RAS (and surfaceRAS) as well as TKReg RAS (orig) coordinates. Following the steps laid out on the CoordinateSystems web page I can convert back and forth between those coordinate systems. However, I can't figure out what I need to do to calculate the Vertex coordinates. I can load lh.pial in matlab and see the (+1) vertex number and coordinates, but I'd like to figure out the best way to get from Vertex x/y/z to TkReg RAS or SurfaceRAS. Is there an easy formula to calculate this? Thanks in advance for any and all responses.
-Joel ________________________________ Notice: This UI Health Care e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521 and is intended only for the use of the individual or entity to which it is addressed, and may contain information that is privileged, confidential, and exempt from disclosure under applicable law. If you are not the intended recipient, any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately and delete or destroy all copies of the original message and attachments thereto. Email sent to or from UI Health Care may be retained as required by law or regulation. Thank you. ________________________________
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
