Hi all,

Is there an equivalent of fslmaths in Freesurfer?  I would like to add two 
scalar value images (.mgh files) that are registered to the fsaverage6 surface 
but I’m not seeing an obvious way to do it.  Right now I’m reading the images 
into Matlab to add them, but this is a bit inconvenient because what I would 
like to do is smooth an image by a small amount, add the original image back to 
it, then smooth again marginally and iterate until I get to a target fwhm.  
Since I can’t smooth inside Matlab this necessitates writing out a temp image 
for each smoothing step then reading it back into Matlab for the adding.  
Obviously this is a solvable problem, but as someone only marginally proficient 
in Matlab it’s something I’d like to avoid, plus it seems like a lot of I/O for 
this task.

A little more detail on my data and what I’m trying to do:

The scalar images I’m working with are network confidence maps, basically like 
the spatial maps from an ICA dual-regression.  I want to combine the confidence 
maps together into a hard partition and write it to an annot file, but I want 
to smooth them first.  I’m concerned, however, that smoothing is going to bias 
the parcellation against small network parcels and in favor of large network 
parcels because in each confidence map the small parcels will be surrounded by 
lots of zeros (does this make sense?).  To correct for this, my idea was to 
iteratively smooth by small amounts and to add the original confidence values 
(or some fraction of them) back to the smoothed map after each iteration so 
that regions of high confidence with a small/narrow spatial spread do not 
become diluted by the smoothing and don’t get taken over by larger high 
confidence regions in nearby networks.

One final question would be how to smooth on a surface without resampling.  
Right now I’m using mri_surf2surf and smoothing when I resample to the native 
mesh, but if I take the above approach I would not want to resample at each 
smoothing step.  Could I just use mri_surf2surf with –srcsubject and 
–trgsubject pointing to the same subject?


Thanks,
Jared
____________________________
Jared P. Zimmerman
jar...@pennmedicine.upenn.edu
Neuroscience Graduate Student
Oathes Lab
University of Pennsylvania


_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.

Reply via email to