Dear Ruopeng, Thank you for the information.
best Peng On Fri, Jan 27, 2017 at 4:10 PM, Ruopeng Wang <rpw...@nmr.mgh.harvard.edu> wrote: > Hi Peng, > > No, there is no command-line option for that. I will add it in future update. > > Best, > Ruopeng > >> On Jan 27, 2017, at 9:49 AM, peng <prio...@gmail.com> wrote: >> >> Dear Freesurfer experts, >> >> When I use Freeview GUI to show overlays on a surface, I can click on >> the button "Configure", and then check the box "Enable" in the smooth >> section (upper right of the pop-out window), to smooth it. Is there >> any options to do similar stuff in the command line of freeview? e.g. >> when I want to generate a lot of screenshots by the -ss option. >> Thank you in advance! >> >> best >> Peng >> _______________________________________________ >> Freesurfer mailing list >> Freesurfer@nmr.mgh.harvard.edu >> https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer >> >> > > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > > The information in this e-mail is intended only for the person to whom it is > addressed. If you believe this e-mail was sent to you in error and the e-mail > contains patient information, please contact the Partners Compliance HelpLine > at > http://www.partners.org/complianceline . If the e-mail was sent to you in > error > but does not contain patient information, please contact the sender and > properly > dispose of the e-mail. > _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
