Dear Freesurfer experts, When I use Freeview GUI to show overlays on a surface, I can click on the button "Configure", and then check the box "Enable" in the smooth section (upper right of the pop-out window), to smooth it. Is there any options to do similar stuff in the command line of freeview? e.g. when I want to generate a lot of screenshots by the -ss option. Thank you in advance!
best Peng _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
