Dear all, I've a lot of patients and we are looking for the fastest solution to check the output of Freesurfer. On the troubleshooting page ( https://surfer.nmr.mgh.harvard.edu/fswiki/FsTutorial/TroubleshootingData) there are a lot of steps to check, but I think not all of that should be done to find out whether there is error in the final segmentations. I think, but I am not sure, that checking the surfaces (white and pial) and checking the subcortical segmentations (aseg) is enough to realize if something is wrong. After an error is detected based on the checked outputs (surfaces and aseg), we can find out the exact nature of the error and correct it based on the troubleshooting page. Is it a good solution for verifying the performance of Freesurfer by checking only these two things (surfaces and aseg) or I need to check all of the steps listed on the troubleshooting page anyway?
Best Regards, Gabor <petzinger.ga...@gmail.com>
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
