Hello, I would like to work with mesh representation of pial and white surfaces in vtk format. To do that, I use the following syntax: mris_convert lh.pial lh.pial.vtk
However, there is a small issue after conversion: the vector called 'c_ras' (the RAS at the 'center' of the volume according to mri_info) is not taken into account. I can manually add this c_ras vector to correct that but I was wondering if there was any flag for mris_convert or a special command to do that ? This kind of flag exists for mri_tesselate (with -n flag which ables to "save surface with real RAS coordinates where c_(r,a,s) != 0") so I was hoping the same kind of flags for mris_convert. Thanks in advance for your answer ! Alexandre
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
