Hi Corinna can you send us your full command line? Sounds like you are using a surface overlay as the cover_seg parameter instead of a volume one. Try running mri_info on it to make sure it is a volume (i.e. 256x256x256). If not, you will need to sample it into the volume with mri_surf2vol
thanks Bruce On Thu, 18 Feb 2016, Corinna Bauer wrote: > Hello all, > I am attempting to reshape the pial surfaces to fill the new boundaries in > my edited ribbon.mgz file. I am using mris_make_surfaces with the -cover_seg > flag but keep getting this error: > ERROR: mris_make_surfaces-MRIcheckVolDims: volume1 height=256 != volume2 > height=1. > > Any suggestions? > > Thanks! > Corinna > > FYI: I am trying to reshape the pial boundary based off this previous > thread. > https://mail.nmr.mgh.harvard.edu/pipermail///freesurfer/2014-November/04134 > 8.html > > _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
