Dear FS experts,I got into a trouble when used the command of mri_vol2surf.I
planned to project a volume file (left hemisphere) onto the surface (lh) of the
same subject. While i got nothing (value=0 for nearly all the vertexes except
for a few valued vertexes on the medial surface). However, i tried to project
this volume (lh) file onto the surface of rh, some vertexes were valued, but
the dimension seems abnormal.
I guess there may be something wrong with the coordinate system of this volume
file. This volume file was initially generated from the command of mri_surf2vol
as a mask (which can be projected to the surface correctly), and i assigned
some values to this mask volume then generated this problematic volume file (as
attached). So where is the problem?Thank you so much for any help!!!Best
Regards,kaiThe Chinese University of Hong Kong
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
