Hi Rujing
run:
recon-all -s <subject> -make all
that will figure out what needs to be rerun and do so.
cheers
Bruce
On Thu, 21 Nov 2013,
Rujing Zha wrote:
Dear all,
I have run recon-all for some subjects,but this code is unexpected
terminated before it normally end. Can I run the code agian directly without
deleting some outputs obtained from recon-all? That is to say, part of
recon-all outputs do exist(as I have run recon-all previously), then
recon-all new output will overwrite the existing files when I run recon-all
again?
All the best.
2013-11-21
____________________________________________________________________________
Rujing Zha
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
