Hi Tricia,
try
recon-all -long subject001 subject001_base -localGI
Best, Martin
On 09/28/2013 01:53 PM, Tricia Merkley wrote:
Hi,
Is it possible to run the LGI on data that has already been
longitudinally processed?
For example, when I try to run:
recon-all -s subject001.long.subject001_base -localGI
I get the following error:
ERROR: Are you trying to run or re-run a longitudinal time point?
If so, please specify the following parameters:
\' -long <tpNid> <templateid> \'
where <tpNid> is the time point id (SAME as cross sectional
ID) and <templateid> is the ID created in the -base run.
The directory <tpNid>.long.<templateid> will be created
automatically or used for output, if it already exists.
This is using v5.1.0, and no, I'm not trying to re-run a longitudinal
time point. Just the LGI. I'd appreciate any suggestions!
Thanks so much,
Tricia
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
--
Martin Reuter, Ph.D.
Assistant in Neuroscience - Massachusetts General Hospital
Instructor in Neurology - Harvard Medical School
MGH / HMS / MIT
A.A.Martinos Center for Biomedical Imaging
149 Thirteenth Street, Suite 2301
Charlestown, MA 02129
Phone: +1-617-724-5652
Email:
mreu...@nmr.mgh.harvard.edu
reu...@mit.edu
Web : http://reuter.mit.edu
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
