Hi Freesurfers, I have problems with the troubleshoot of a scan that didn't run at all within autorecon (while the scan actually looks good). So I ran the skullstrip manually and came across the following phenomenon: -when using waterthreshold 25 it gives me an error message and no brainmask.mgz file gets created -when using waterthreshold 24 or lower big chunks of the brain go missing and most of the skull stays I am not sure the manual editing will be a good approach as I would have to remove the complete skull Any suggestions how I could get the skullstrip work? Thank you, Anne
### UNIVERSITY OF CAPE TOWN This e-mail is subject to the UCT ICT policies and e-mail disclaimer published on our website at http://www.uct.ac.za/about/policies/emaildisclaimer/ or obtainable from +27 21 650 9111. This e-mail is intended only for the person(s) to whom it is addressed. If the e-mail has reached you in error, please notify the author. If you are not the intended recipient of the e-mail you may not use, disclose, copy, redirect or print the content. If this e-mail is not related to the business of UCT it is sent by the sender in the sender's individual capacity. ###
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
