Hi all, I haven't had any answer to my post, so I give another try. Hope it doesn't bother you.
I am trying to overlay a map on a specific subcortical structure (the caudate). -I obtained the surface of the structure using the command: mri_tessellate structure.nii.gz 1 lh.structure.surf -then I projected my map on the surface using: mri_vol2surf --mov map.nii --regheader structure --hemi lh --surf structure.surf --projdist 0 --fwhm 5 --out projected_map.mgz --interp trilinear Everything seems to work properly. I am able to see the result using tksurfer. However, when I try to overlay projected_map.mgz on lh.structure.surf using freeview I experience a segmentation fault issue. It seems that the software looks for the WM, the pial, the curv, etc surfaces. Obviously I don't have these information, since I am projecting the map only on the caudate nucleus. Is it mandatory to have these inputs? Could you give me an advice about that? Thanks Maria _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
