Dear freesurfers,
I am trying to convert a surface label into a volume file so that it can subsequently be viewed as a 3-D model. To create the label I've followed the steps from http://www.ci.uchicago.edu/wiki/bin/view/HNL/EditROI and have thus edited my color table LUT file. The command I am using for this is mri_label2volume: mri_label2vol --label test.label --temp brainmask.mgz --reg mni152.register.dat --proj frac 0 1 .001 --subject one --hemi lh --o test.mgz However, the resultant volume file from this command is splotchy and thus does not look ideal when viewed in tkmedit. Decreasing the delta to very small values had no effect in making the volume render better. Is there another way to convert a surface label that has been hand drawn in tksurfer into a volume file that is anatomically correct? Thanks very much for your help Prapti
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
