Dear surfers, Hi, I used freeesurfer to visualize my volume from FEAT outputs on the surface in the way:
tksurfer fsaverage rh inflated_pre -overlay data.nii.gz -mni152reg , then save surface overlay as a mgh file. My question is, how can I get the identical mgh data by using a command line without launching the tksurfer gui? I found there is a command mri_vol2surf, but not sure about these default settings in tksurfer gui. Really appreciate it if some know and like to give your suggestions. -- Xinian Zuo, Ph.D Associate Research Scientist Institute for Pediatric Neuroscience NYU Child Study Center 215 Lexington Ave., 14th Floor New York, NY 10016 Phone: (212) 263 2485 _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
