Hi, there,
I have two questions about the ?h.thickness file.
If I load a subject's surface ?h.inflated using tksurfer, then I load its
thickness file ?h.thickness,
By clicking mouse on the surface, I can read the corresponding curvature value
of a specific vertex.
Q1, Here, the value next to 'Curvature' is actually its thickness value, right?
Q2, If I select four vertexes on the surface, is there a way that I can save
the thickness values of these four vertexes into a txt file?
Thanks!
Guang
_________________________________________________________________
Hotmail is redefining busy with tools for the New Busy. Get more from your
inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID27925::T:WLMTAGL:ON:WL:en-US:WM_HMP:032010_2_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
