Hello, I was searching through the wiki and ran across a page that said to use csurf to make full surface cuts in order to ultimately create flattened surfaces. But while perusing the support archives, it was said that csurf is no longer supported. Is this true? How then do you make the full surface cuts needed to create the flattened surfaces?
Thanks Adam adam __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
