about how long should the flattening process take? mris_flatten took about nine hours when I tried it yesterday.
adam --- Bruce Fischl <[EMAIL PROTECTED]> wrote: > use tksurfer. > > On Wed, 31 May 2006, adam walczak wrote: > > > Hello, > > > > I was searching through the wiki and ran across a > page > > that said to use csurf to make full surface cuts > in > > order to ultimately create flattened surfaces. > But > > while perusing the support archives, it was said > that > > csurf is no longer supported. Is this true? How > then > > do you make the full surface cuts needed to create > the > > flattened surfaces? > > > > Thanks > > > > Adam > > > > adam > > > > __________________________________________________ > > Do You Yahoo!? > > Tired of spam? Yahoo! Mail has the best spam > protection around > > http://mail.yahoo.com > > _______________________________________________ > > Freesurfer mailing list > > Freesurfer@nmr.mgh.harvard.edu > > > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > > > > > > adam __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
