On Thu, Jan 14, 2010 at 04:33:19AM +0100, Floris Bos wrote: > Hi, > > On Thursday 14 January 2010 03:54:52 am Pyun YongHyeon wrote: > > > == > > > bge0: <HP NC107i PCIe Gigabit Server Adapter, ASIC rev. 0x5784100> mem > > > 0xdf900000-0xdf90ffff irq 16 at device 0.0 on pci32 > > > == > > > > > > After boot, the network works for about 5 seconds, barely enough time to > > > get an IP by DHCP, and sent a ping or 2. > > > Then network connectivity goes down, and after some time there is a > > > "bge0: watchdog timeout -- resetting" message. > > > > > > Then network works again for 5 seconds, and goes down again. All the > > > time, repeatedly. > > > > > > The system works fine under Ubuntu. So I assume the hardware is ok. > > > > > > > I'm not sure but it looks like you have a BCM5784 controller. What is > > the output of "devinfo -rv | grep phy"? > > == > ukphy0 pnpinfo oui=0x50ef model=0x3a rev=0x4 at phyno=1 > ukphy1 pnpinfo oui=0x50ef model=0x3a rev=0x4 at phyno=1 > ==
Support for the PHY was added in r202269. Please try again after applying the change. Or you can download sys/dev/mii/miidevs and sys/dev/mii/brgphy.c from HEAD and rebuild kernel. > > According to the specs in the HP manual it is supposed to be a BCM5723 ( > http://www.dectrader.com/docs/set5/c01931407.pdf ) > > > Yours sincerely, > > Floris Bos _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
