On Thu, Jan 14, 2010 at 01:40:05AM +0000, Floris Bos wrote: > The following reply was made to PR kern/92090; it has been noted by GNATS. > > From: Floris Bos <i...@je-eigen-domein.nl> > To: bug-follo...@freebsd.org > Cc: > Subject: Re: kern/92090: [bge] bge: watchdog timeout -- resetting > Date: Thu, 14 Jan 2010 02:14:07 +0100 > > This might be a different problem, but I add it to this bug as I am getting > the same error message. > > > I have a brand new HP DL120 G6 server which has an on-board NIC that is > based on the BCM5723 chipset. > The NIC is not supported/recognized by FreeBSD 8, but the FreeBSD 9 (January > snapshot) identifies it as: > > == > bge0: <HP NC107i PCIe Gigabit Server Adapter, ASIC rev. 0x5784100> mem > 0xdf900000-0xdf90ffff irq 16 at device 0.0 on pci32 > == > > After boot, the network works for about 5 seconds, barely enough time to get > an IP by DHCP, and sent a ping or 2. > Then network connectivity goes down, and after some time there is a "bge0: > watchdog timeout -- resetting" message. > > Then network works again for 5 seconds, and goes down again. All the time, > repeatedly. > > The system works fine under Ubuntu. So I assume the hardware is ok. >
I'm not sure but it looks like you have a BCM5784 controller. What is the output of "devinfo -rv | grep phy"? _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"
