Dear Maren,
I did not notice anything special in the Cisco 1600 router config. as shown below :-
! hostname example.com no service udp-small-servers no service tcp-small-servers ! ip sub-net-zero ip classless ip routing ! enable-password ***** ! interface FastEthernet 0 description To Intranet ip address 1.2.3.4 255.255.255.224 no ip directed broadcast no shutdown ! interface Serial 0 description To MCI bandwidth 1536 encapsulation frame-relay IETF frame-relay lmi-type ansi no ip address no shutdown no fair-queue ! interface Serial 0.1 point-to-point ip unnumbered FastEthernet0 frame-relay interface-dlci 500 IETF bandwidth 1536 no shutdown ! ip route 0.0.0.0 0.0.0.0 Serial 0.1 ! ip domain-name ALTER.NET ip name-server 198.6.1.5 snmp-server community .... ....
How to put the same serial config. on ARNET/Digi SYNC/570i with Netgraph + Frame Relay? If it would be easier to work with Sangoma S5141, then how to convert into the Sangoma config. with Netgraph?
Thanks a lot.
John Mok
Maren S. Leizaola wrote:
On Sun, 13 Mar 2005, John Mok wrote:
Hi,
I would like to replace the existing Cisco router 1600 and connect to MCI Hong Kong with FeeBSD 5.3 box with a Digi SYNC 570 serial card. With reference of the FreeBSD handbook and the information from Julian Elischer at
http://www.elischer.org/netgraph/
John,
Are you sure that you have moved all the items you need from the cisco config to FreeBSD... I've not played with netgraph, but if I recall correctly your configuration needs to also match what PCCW have configured, in particular the sub-interface... s0.100 etc...
regards, maren.
_______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
