I fould the following announcement:
http://article.gmane.org/gmane.comp.debugging.openocd.devel/17362
So ulink is supported by openocd, not sure if ulink2 is compatible with
ulink.
from what I have googled about ulink2 it seems that it is closely bound
to the uVision Debugger from Keil and they do not seem to provide a
gdbserver.
So if ulink support in openocd does not work for you I would propose
that you spend approx. 25 Euros and buy a stlink V2 interface or
ARM-USB-TINY-H <https://www.olimex.com/Products/ARM/JTAG/ARM-USB-TINY-H>
from Olimex (EUR40),
I own both and they work just fine with openocd.
I have no plans to make ulink2 work, I have created an interface for
openocd (which provides a gdbserver) that can be used to interface with
different jtag debugging interfaces. http://openocd.sourceforge.net/
Michael
Am 13.03.13 13:16, schrieb Justin Smyth:
Sorry of this cross posts but i wasn't sure where to send this
question to.
I am currently using a LPC 1343 Microprocessor board and i have
recently purchased a ULINK2 debugging kit from china.
i am aware that there are plans to allow debugging these boards using
the UNLINK2, but it wasnt something that is currently available
could i get some help so i can use the UNLINK2 device to debug my
board , i want to be able to write some code in lazarus , upload it to
the board and debug it
I do believe micheal ring was talking bout this
Kind Regards
Justin
ps if you get this and email me back you prob wont get any replies for
8 or so hours as its after 11pm here in Melbourne AU , i'm off to bed
need some sleep.
_______________________________________________
fpc-devel maillist - [email protected]
http://lists.freepascal.org/mailman/listinfo/fpc-devel
_______________________________________________
fpc-devel maillist - [email protected]
http://lists.freepascal.org/mailman/listinfo/fpc-devel
