On 9/30/26 13:42, Stuart Stevenson wrote:
Surface Feed per Minute is only relevant on a turning process. On a milling
process the SFM is determined by the spindle speed.
How is this determined if B is turning 500 rpms while Y is moving 400mm
and the radii of the B is about 1"?, carving a bolt's 4x6 buttress
thread in hard maple at a 12mm pitch? One start while going down the
stick, 2nd start while coming back to the starting point?
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
