Looking at that *.3mf file I can see the cause of the problem, There are 39 non-default settings but the big problem is near the top. See the screenshot below.
The "line width" is set to 0.3 and there is a 0.4 nozzle on the printer. This is a perfect way to simulate the effect of a clogged-up nozzle. Also this part does NOT need a "super quality" layer hight. All the lines are vertical so a small z-axis step does nothing. Try setting this to about 0.2 and get a faster print. This has to be the problem. I thought about actually printing this to see if I can duplicate the failed print. But I think the cause is obvious now [image: Genes3mf.jpeg] On Sat, Jun 6, 2020 at 11:53 AM Thaddeus Waldner <[email protected]> wrote: > Correction: > "lathe-stf/“ > Full address: > http://geneslinuxbox.net:6309/gene/lathe-stf/ > > > The server is being a cast iron bitch, instant reject notices even when > > its smaller than the 360k stated limit. So its in the usual place, > > click on the link in my sig, and when you see our now old pix, > > add "lathe.stf/" to the address bar, and its the only CE3PRO file there. > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Chris Albertson Redondo Beach, California
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
