On Saturday 06 June 2020 14:01:52 Chris Albertson wrote: > DO I read this as using 0.3mm line width? If the nozzle has a 0.4mm > hole you must set the line width to 0.4.
I don't recall setting that, it was an autoselected choice that I think came with the super quality setting. If I make it bigger, how much bigger? > Cura will run the extruders at a rate that pumps plastic to make a > linewitdth x layerthickness x speed. So if you say 0.3 line, then it > will pump out 3/4 as much plastic as required and move over 0.3 to > print the next line and will mess up what it just printed. > > The 3mm wall and also explains your very long print times. I'm > making usable 40T pulleys in one hour 10 minutes > > I would print with all default settings but do enable support > "everywhere" as it will only be used if needed. At least until you > get a good looking 5mm test cube. > > On Sat, Jun 6, 2020 at 10:34 AM Gene Heskett <[email protected]> wrote: > > On Saturday 06 June 2020 13:01:32 andy pugh wrote: > > > On Sat, 6 Jun 2020 at 17:56, Gene Heskett <[email protected]> > > > wrote: > > > > > > Here ya go Andrew. A bit fuzzier on the far side, > > > > > > > > > Do you have any wall at all? That looks to be _all_ infill. > > > > To me too. > > > > > In "Quality" what is your > > > > "Wall line width" =0.3 > > > > > and then in "Shell" what is your > > > > "Wall thickness" =3.0mm > > > > > and > > > > "Wall line count" =10.0 > > > > Thanks Andy > > > > Cheers, Gene Heskett > > -- > > "There are four boxes to be used in defense of liberty: > > soap, ballot, jury, and ammo. Please use in that order." > > -Ed Howdershelt (Author) > > If we desire respect for the law, we must first make the law > > respectable. - Louis D. Brandeis > > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
