Not sure I understand what you meant here. > -----Original Message----- > From: N [mailto:[email protected]] > Sent: February-23-20 1:12 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] about NML - RCS_CMD_CHANNEL/EMC_CMD_MSG > - EMC_AUX_ESTOP_ON > > > @ John Dammeyer > > > > I'm quite sure that labview project at least work great .... the difficult > > is study lcnc code (write in a good way but not rich of comment ... on the > > other hand, I agree not to comment too much on his code) > > Something adding some comments to code then you read it? > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
