Thanks .... I try to ask on forum .... not see that thread previously. I read now but not see things that can help me.
I make somethings of similar with modbus .... work well but there is not a fast response with (max 50ms) .... someone suggested me sdi bus .... but is not my ideas ... so that the solution of using nml c ++ in a parallel thread compared to the gui seemed to me the most suitable solution for a data refresh within 5ms. Obtain STATUS is quite simple ... sending command I not understand how to do. On the other hand, debugging can only be obtained on the terminal (I use linuxcnc-dev userspaces on my test machine), and for me that I'm not used to, it creates a bit of misunderstanding. regards bkt Il giorno mar 17 dic 2019 alle ore 11:04 andy pugh <[email protected]> ha scritto: > On Mon, 16 Dec 2019 at 18:46, theman whosoldtheworld > <[email protected]> wrote: > > > Not understand very well these point .. > > Nor do I. > I feel that his thread here might have touched on some of the same issues. > > https://forum.linuxcnc.org/41-guis/36920-labview-ui-project-for-linuxcnc?start=0 > > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1912 > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
