On Mon, 11 Sep 2017 13:16:00 +0200 theman whosoldtheworld <[email protected]> wrote:
> why not powerlink ie? no need special chip, no need special hardware ... > but it run on every device ... so you can must to limit it to a single core > realtime working ... so other core is free for Lcnc ... not tested yet with > Lcnc istances so I'm not able to report latency performance with Lcnc > istance + powerlink ie istances ... its only limit is that there are few > device manufacturers who use it, ... It might actually be a good choice and as POWERLINK Ethernet protocol comply with authorized standardization level for communication technologies in China plenty of devices could be expected. https://www.ceasiamag.com/2012/05/powerlink-awarded-national-standard-in-china/ ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
