On Friday 08 September 2017 16:13:20 Gene Heskett wrote: > On Friday 08 September 2017 15:32:59 John Kasunich wrote: [...] > Which is essentially what I did. And got the wrong size. :( In the > right direction so it was eventually correctable to a fit given the > rust on the shaft as it was outdoors for 40 years at the local > horsepistol. > > Cheers, Gene Heskett
I superglued that scale on tonight, found my x backlash was about .00475 instead of .0021, but I know exactly where it is, and what sort of a b---ch it will be to tighten it, so I just readjusted the backlash in LCNC for the time being. I also found the scale value set in LCNC was about 5.0015" too far in 5" of travel. So thats a never mind and I didn't adjust it. So I am still puzzled by dialing in a -0.0500" cut, and only getting a .0324" radius change. Next I think is an empty toolholder against the side of the chuck and push while watching the chuck with a .0001" DI till it cogs once as a brute force spindle bushing test. Thanks everybody. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
