The original Anliam drives and power supply. JT
On 1/10/2016 2:41 PM, Dave Cole wrote: > My mistake, gotta clean my glasses apparently. > > What are you using for axes drives? > > Dave > > On 1/10/2016 3:35 PM, John Thornton wrote: >> I don't have AB drives... I have a filter on my GS2 and another one >> after the control transformer. >> >> JT >> >> On 1/10/2016 11:40 AM, Dave Cole wrote: >>> Do you have filters just prior to the input power on the AB Servo drives? >>> >>> I've also had problems with Teco servo drives backfeeding noise into the >>> AC line and messing with Mesa boards. >>> An input filter from AD fixed that problem as well. >>> >>> Dave >>> >>> On 1/10/2016 6:44 AM, John Thornton wrote: >>>> Well none of the suggestions about star grounding did any good. In fact >>>> they made the problem worse than before, so bad I could not even get 2.6 >>>> to run. Off this list I was sent the AB servo best wiring practices pdf >>>> which explained how to reduce noise in a servo drive enclosure. I >>>> followed the advise as much as possible and after removing all my ground >>>> wire antennas I was back running with an occasional sserial error. The >>>> short explanation is to terminate the shields to a ground plane as close >>>> as possible to the point where you take the shield/drain wire from the >>>> cable. I still have a cable bundle running to my switch box that is >>>> parallel wires and I might replace that with some twisted pairs. Photos >>>> at 11. >>>> >>>> JT >>>> >>>> ------------------------------------------------------------------------------ >>>> Site24x7 APM Insight: Get Deep Visibility into Application Performance >>>> APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month >>>> Monitor end-to-end web transactions and take corrective actions now >>>> Troubleshoot faster and improve end-user experience. Signup Now! >>>> http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 >>>> _______________________________________________ >>>> Emc-users mailing list >>>> [email protected] >>>> https://lists.sourceforge.net/lists/listinfo/emc-users >>> ------------------------------------------------------------------------------ >>> Site24x7 APM Insight: Get Deep Visibility into Application Performance >>> APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month >>> Monitor end-to-end web transactions and take corrective actions now >>> Troubleshoot faster and improve end-user experience. Signup Now! >>> http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 >>> _______________________________________________ >>> Emc-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/emc-users >> ------------------------------------------------------------------------------ >> Site24x7 APM Insight: Get Deep Visibility into Application Performance >> APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month >> Monitor end-to-end web transactions and take corrective actions now >> Troubleshoot faster and improve end-user experience. Signup Now! >> http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ > Site24x7 APM Insight: Get Deep Visibility into Application Performance > APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month > Monitor end-to-end web transactions and take corrective actions now > Troubleshoot faster and improve end-user experience. Signup Now! > http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
