On Monday, January 12, 2015 12:25:12 PM Todd Zuercher did opine And Gene did reply: > If you only need a 1/16" radius, why not just touch the corners of the > plugs with a bit of sandpaper. It will be a lot of fiddly work, but > probably not much more time and effort than what you've put into > trying to automate it. (saying you could have been done by now)
You are correct to use the word fiddly. I already have a socket cut in micarta to hold them while they get a haircut. I figure about a minute a chip once I get started. And in ebony, any errors in the contour stick out like a sore thumb as it will be polished with 0000 steel wool making it glossy by the time a few coats of Sam's Stuff has been applied.. > ----- Original Message ----- > From: "andy pugh" <[email protected]> > To: "Enhanced Machine Controller (EMC)" > <[email protected]> Sent: Monday, January 12, 2015 > 12:12:59 PM > Subject: Re: [Emc-users] My google-foo is broken, again. > > On 12 January 2015 at 17:07, Gene Heskett <[email protected]> wrote: > > Andy found the right one I can modify for no pilot operation, > > Actually, I am not sure I did. Those look to be 1/8" radius, not 1/16" > radius. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> US V Castleman, SCOTUS, Mar 2014 is grounds for Impeaching SCOTUS ------------------------------------------------------------------------------ New Year. New Location. New Benefits. New Data Center in Ashburn, VA. GigeNET is offering a free month of service with a new server in Ashburn. Choose from 2 high performing configs, both with 100TB of bandwidth. Higher redundancy.Lower latency.Increased capacity.Completely compliant. www.gigenet.com _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
