That would be a good case for a G68, but I see that command does not seem to exist. Maybe it should.
Regards, Marcus On 22 Oct 2013, at 14:29, andy pugh wrote: > I need to cut some partial holes for a taperlock bush. > > I know that the holes are at 1.38" radius and 85 degrees. So I can > very readily move the tool to the hole centre using polar coordinates. > > However, once there I want to spiral-mill. > > I don't think that is it possible to use G91.1 arc centres and polar > coordinates? > > Is there a better way to do this than to do a polar move to the hole > centre, then G92 X0 Y0 and then do G90.1 spiral milling before > clearing G92 to move to the next hole? > > > -- > atp > If you can't fix it, you don't own it. > http://www.ifixit.com/Manifesto > > ------------------------------------------------------------------------------ > October Webinars: Code for Performance > Free Intel webinars can help you accelerate application performance. > Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from > the latest Intel processors and coprocessors. See abstracts and register > > http://pubads.g.doubleclick.net/gampad/clk?id=60135991&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ October Webinars: Code for Performance Free Intel webinars can help you accelerate application performance. Explore tips for MPI, OpenMP, advanced profiling, and more. Get the most from the latest Intel processors and coprocessors. See abstracts and register > http://pubads.g.doubleclick.net/gampad/clk?id=60135991&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
