On Mon, 2009-06-15 at 00:09 -0500, Jon Elson wrote: > Kirk Wallace wrote: > > I replaced the PC and ran an air part. I noticed that the screen blanked > > near slot 19, but the I got the screen back with the mouse and the part > > completed with out interruption. I disabled the screen saver and ran two > > more air parts which completed properly. I set up the real part, and it > > stopped at the same spot in slot 19 as before. I jogged out of the hole, > > disabled radius compensation with g40, then did g28 and the spindle > > headed back for the hole. I have no idea how to troubleshoot this. I > > didn't see anything in dmesg. Anyone have any ideas? Oh this time I used > > EMC2 2.3.1 on 8.04. Thanks. > > > It sounds like you need to determine what the difference is between > cutting air and > cutting metal. Is it the Z coordinates?
For the most part only the X was change to get away from the vise. > Is it because the spindle > drive is on? I had both the spindle and mist (without fluid) on. > You may have to send the program to one of the developers for a trial run. > > Jon I doubt that EMC2 is the cause but rather is reacting to the fault. I need to think more about how this could happen without setting an alarm and moving home to the last tooling position. Another problem is that it takes 20 minutes to get to the nineteenth hole. So testing is a problem. Maybe the CNC god is a sadistic golfer, so I need to think like one. I think I'll change one commonality which is 2.3.1 back to 2.2 if I can find an old disk. To change the mill itself, I'd have to finish the Bridgeport, which I should consider a piece of art because it never seems to get finished. Just in case, the file is here: http://wallacecompany.com/machine_shop/EMC2/ngc/encoder-100ppr-4c.ngc the config is not much more than the standard stepper config: http://www.wallacecompany.com/machine_shop/Shizuoka/emc2/configs/ST-N_current/ -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/index.html California, USA ------------------------------------------------------------------------------ Crystal Reports - New Free Runtime and 30 Day Trial Check out the new simplified licensing option that enables unlimited royalty-free distribution of the report engine for externally facing server and web deployment. http://p.sf.net/sfu/businessobjects _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
