On Fri, 2009-06-12 at 22:22 -0700, Kirk Wallace wrote: > In case anyone is interested, I have an .ngc file that I'll probably run > tomorrow, but if anyone finds anything that might improve it, I would > appreciate hearing from you. Thanks. > > http://wallacecompany.com/machine_shop/EMC2/ngc/encoder-100ppr-4c.ngc >
I tried making the part tonight and ran into a problem. I did a dry run in air which stopped at slot 19 of 25. I rebooted, re-ran the part and it ran fine. I touched off on the material, ran the part, but again it stopped on slot 19. I tried one more time with no luck. It ran fine in the office on a sim config. When the machine stops the stop button in AXIS is active and AXIS is in manual mode with the spindle and mist running, but I can press spindle stop and mist to turn them off and jog fine, so it seems it's in normal manual mode. Could bad memory or other PC hardware do this? I'll try to swap out the PC and try again. EMC2 is 2.3.1 running on 6.04. Also, I jogged out of the slot, cleared the compensation with g40 and did a g28, which ran the tool into the vise (no length comp was used). It may have tried this on the last run, but I hit e-stop before it could get too far. -- Kirk Wallace http://www.wallacecompany.com/machine_shop/ http://www.wallacecompany.com/E45/index.html California, USA ------------------------------------------------------------------------------ Crystal Reports - New Free Runtime and 30 Day Trial Check out the new simplified licensing option that enables unlimited royalty-free distribution of the report engine for externally facing server and web deployment. http://p.sf.net/sfu/businessobjects _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
