I have to agree. There are so many times where this is useful or even vital for a particular job. I understand the difficulties involved in stopping halfway through a move but would it be possible to have an option to stop at the end of the current move (or the end of the lookahead queue) then allow jogging? All emc has to do then is record the current position. Once you have finished jogging emc can move back to the recorded position and carry on. The same would apply for a tool change.
Les Steve Blackmore wrote: > The encoder support in EMC is very good, however the pause leaves a lot > to be desired compared to Mach. > > It's not possible to Jog during a feed hold or pause in a program to > zero a tool or clear swarf. > ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
