Make sure the or2 function is added to a thread (probably the servo thread).
Regards, Alex ----- Original Message ----- From: "Kasey Matejcek" <[email protected]> To: <[email protected]> Sent: Wednesday, January 07, 2009 4:15 AM Subject: [Emc-users] Estop universal PWM > Is there a way to have emc come out of estop and be in estop reset > > When I hit the reset button for the estop chain on my machine > > Witch pin do I need to link to to make this happen I've messed around and > haven't got anywere to speak of > > I tied ppmc.0din.14.in to estop-latch.0.reset this work some of the time > but > no always and then it disables the F1 key from resting the estop because > I've unlinked that > > I tried to Or that input together and that didn't seem to work ether > > > > Newsig Estop-reset-1 bit > > Linksp Estop-reset-1 ppmc.0.din.14.in > > Linksp Estop-reset-1 or2.0.in0 > > > > Newsig Estop-reset-2 bit > > Linksp Estop-reset-2 iocontrol.0.user-enable-out > > Linksp Estop-reset-2 or2.0.in1 > > > > Newsig Estop-reset-3 bit > > Linksp Estop-reset-3 or2.0.out > > Linksp Estop-reset-3 estop-latch.0.reset > > > > But after looking in showhal and watching the or2.0.out I never see it go > high > > The input for the or seem to work press the F1 key or2.0.in1 goes high > > Hookup pin 14 and or2.0.in0 goes high > > But never see or2.0.out go high > > I'm miss understanding something with this or I'm I not using the right > pins > for this to work > > ------------------------------------------------------------------------------ Check out the new SourceForge.net Marketplace. It is the best place to buy or sell services for just about anything Open Source. http://p.sf.net/sfu/Xq1LFB _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
