Is there a way to have emc come out of estop and be in estop reset When I hit the reset button for the estop chain on my machine
Witch pin do I need to link to to make this happen I've messed around and haven't got anywere to speak of I tied ppmc.0din.14.in to estop-latch.0.reset this work some of the time but no always and then it disables the F1 key from resting the estop because I've unlinked that I tried to Or that input together and that didn't seem to work ether Newsig Estop-reset-1 bit Linksp Estop-reset-1 ppmc.0.din.14.in Linksp Estop-reset-1 or2.0.in0 Newsig Estop-reset-2 bit Linksp Estop-reset-2 iocontrol.0.user-enable-out Linksp Estop-reset-2 or2.0.in1 Newsig Estop-reset-3 bit Linksp Estop-reset-3 or2.0.out Linksp Estop-reset-3 estop-latch.0.reset But after looking in showhal and watching the or2.0.out I never see it go high The input for the or seem to work press the F1 key or2.0.in1 goes high Hookup pin 14 and or2.0.in0 goes high But never see or2.0.out go high I'm miss understanding something with this or I'm I not using the right pins for this to work -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. ------------------------------------------------------------------------------ Check out the new SourceForge.net Marketplace. It is the best place to buy or sell services for just about anything Open Source. http://p.sf.net/sfu/Xq1LFB _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
